Operation; Removing/Inserting The Battery; Checking The Charge Status Of The Rechargeable Battery; Used Batteries - Parkside PAP 20 B1 Traduction Des Instructions D'origine

Operation

Removing/inserting
the Battery
Only insert the re-
chargeable battery
once the battery-
operated tool is
ready for use.
Risk of injury!
1. To remove the battery (4)
from the appliance, press the
release button (1) on the bat-
tery and pull out the battery.
2. To insert the battery (4),
place it on the guide track
and push it into the appli-
ance. It will audibly snap in.
Checking the charge
status of the re-
chargeable battery
The battery charge status indi-
cator (3) signalises the state of
charge of the battery (4).
Press the button (2) on the bat-
tery. The state of charge of the
battery is displayed by illumi-
nating the 3-colour LED lights of
the state of charge display.
3 LEDs light up
(red, orange and green):
Battery is fully charged.
2 LEDs light up
(red and orange):
Battery has a residual charge.
1 LED lights up (red):
Battery has to be charged
Only charge the battery
(4) when the red LED on
the charge status indica-
tor (3) is on.

Used batteries

• If a fully recharged bat-
tery lasts for considerably
shorter operating times,
the battery is used up and
needs to be replaced. Only
use an OEM battery pack
replacement available from
our Customer Service.
GB IE
23