Refrigerator Doors; Door Alignment - GE 23 Manuel D'utilisation

About the refrigerator doors.
When the door is only partially open,
it will automatically close.
Beyond this stop the door will stay open.
7/16" Wrench
Raise
Screw down the support
leg until it touches the
floor. This will prevent
door misalignment.
12

Refrigerator Doors

The refrigerator doors may feel different than
the ones you are used to. The special door
opening/closing feature makes sure the
doors close all the way and are securely
sealed.
When opening and closing the door, you will
notice a stop position. If the door is opened
past this stop point, the door will remain
open to allow you to load and unload food
more easily. When the door is only partially
open, it will automatically close.

Door Alignment

If doors are uneven, adjust the refrigerator
door.
Using a 7/16" wrench, turn the door
adjusting screw to the right to raise
the door, to the left to lower it. (A nylon
plug, imbedded in the threads of the pin,
prevents the pin from turning unless
a wrench is used.)
Support Leg
(on some models)
Before moving the refrigerator, you will
need to screw up the support leg. Once
the unit is relocated, you will need to screw
down the support leg again.
The resistance you feel at the stop
position will be reduced as the door
is loaded with food.
After one or two turns of the wrench,
open and close the refrigerator door
and check the alignment at the top
of the doors.