Freezer Compartment - GE 23 Manuel D'utilisation

Replacing the light bulbs.
Setting the controls to OFF does not remove power to the light circuit.
Not all features are on all models.
Your light shield will look like one
of the following:
Tabs
OR
Pocket
LED Lighting
Display
18
Refrigerator Compartment—Upper Light
Unplug the refrigerator.
The bulbs are located at the top of
the compartment, inside the light shield.
On some models, a screw at the front of
the light shield will have to be removed.
On other models, the screw is located
in the pocket located at the back of
the light shield.
To remove the light shield, on some
models, press in on the tabs on the sides
of the shield and slide forward and out.
On other models, just slide the shield
forward and out.
Refrigerator Compartment—Lower Light
This light is located above the top drawer.
Unplug the refrigerator.
Remove the convertible meat drawer
control knob by pulling straight out.
Lift the light shield up and pull it out.

Freezer Compartment

Unplug the refrigerator.
Remove the shelf just above the light
shield. (The shelf will be easier to remove
if it is emptied first.) On some models, a
screw at the top of the light shield will
need to be removed.
To remove the light shield, press in
on the sides, and lift up and out.
Dispenser
(on some models)
Unplug the refrigerator.
The bulb is located on the dispenser
under the control panel. Remove the light
bulb by turning it counterclockwise.
Refrigerator Compartment
There is an LED lighting display in the top
of the refrigerator compartment in LCD
models. If this assembly needs to be
replaced, call GE Service at 1.800.432.2737
in the United States or 1.800.561.3344
in Canada.
After replacing the bulb with an
appliance bulb of the same or lower
wattage, replace the light shield and
screws (on some models). When
replacing the light shield, make sure
that the tabs at the back of the shield
fit into the slots at the back of the light
shield housing.
Plug the refrigerator back in.
After replacing the bulb with an
appliance bulb of the same or lower
wattage, replace the shield and
the knob.
Plug the refrigerator back in.
Replace the bulb with an appliance
bulb of the same or lower wattage,
and reinstall the light shield. When
reinstalling the light shield, make sure
the top tabs snap securely into place.
Replace the screw (on some models).
Reinstall the shelf and plug
the refrigerator back in.
Replace the bulb with a bulb of
the same size and wattage.
Plug the refrigerator back in.
(LCD models only)