BENE PORTS Instructions De Montage Et D'utilisation page 13

Table des Matières

Publicité

SAFETY INSTRUCTIONS
23. For the above reasons do not use the
control unit: above or below heat sources
( e.g. heaters), at places exposed to direct
sunlight, in small, unventilated or humid
rooms, near easily flammable materials or
near high-frequency devices (e. g.
mitters, radiation equipment or similar).
Warning: If a fault occurs, then any
attempt to operate the drive before the
safety shutdown is activated may result
in the desktop moving slightly.
Please take care to avoid possible
danger of crushing!
Warning: The collision protection is
inactive during all reset processes
(page 36). Please take care to
avoid possible danger of crushing!
Please note: If the product is visibly
damaged, it must not be installed
or used!
24. After 2 minutes of continuous operation
tran-
the system automatically shuts itself
off and cannot be used for an additional
18 minutes. This keeps the motor from
overheating.
25. Do not exceed maximum
load of 100 kg.
Please note: Tilting the table over the
legs can cause damage.
13

Publicité

Table des Matières
loading

Table des Matières