Ordering Replacement Parts - EINHELL BM 240 Mode D'emploi

BM 240 28.03.2003 9:02 Uhr
GB
(25), as far as possible, for the width required.
Lower the blade guide (11) down to the
workpiece (see 7.5).
Switch on the saw.
Press the edge of the workpiece with your right
hand to hold it securely against the parallel stop
(24) and flat on the table (15).
Guide the workpiece along the parallel stop (24)
and through the blade (26) at a uniform speed.
9.2. Cross cuts (Figure 22)
Slide the cross stop (14) into one of the grooves
in the table (15) and adjust to the required angle
(see 8.3).
Lower the blade guard (10) to the workpiece (see
7.5).
Switch on the saw.
Hold the workpiece securely against the cross
stop (14) and the table (15) and guide it at a
uniform speed through the blade (26).
9.3. Angle cuts and double miter cuts (Figure
(23/24)
9.4. Freehanded cuts (Figure 25)
One of the most outstanding features of a bandsaw
is the ease with which it allows you to make curved
cuts and radii.
Lower the blade guide (11) to the workpiece (see
7.5).
Switch on the saw.
Hold the workpiece securely on the table (15)
and guide slowly through the blade (27).
Freehanded cuts should be made at low feed
speed so that you can guide the blade (27) along
the required line.
It often pays to first cut off surplus curves and
corners up to about 6 mm from the cutting line.
In the case of curves which are too tight for the
blade to cut correctly, it can help to make a
series of close-lying cuts at right angles to the
curved line. When you saw the radius the
material will simply drop off.
10. Maintenance
Caution! Pull out the power plug first.
Remove dust and dirt regularly from the
bandsaw. Cleaning is best carried out with a fine
brush or a cloth.
22
Seite 22
Do not use caustic cleaning agents for cleaning
plastic.

11. Ordering replacement parts

Please provide the following information on all orders
for replacement parts:
Type of machine
Article number of the machine
ID number of the machine
Replacement part number of the part you require
(Please refer to the list of replacement parts).