Automatic System; Switching On/Off - Num'axes CANIFUGUE Guide D'utilisation

autoMatic sYsteM

As soon as the animal wearing the
collar enters the protected area,
he is warned by a beep sound. If he
continues to move forward, towards
the perimeter wire, he receives
stimulations.
The wire is placed on the ground,
buried or raised on an existing fence.
For the system to function, the wire
must form an uninterrupted loop.
Both wires must be spaced 2 meters
apart.

switching on/off


switching on:
Ø
• the transmitter
Switch the transmitter to the On position using the switch button on the left side of the
unit: a green indicator light will come on (cf. Diagram No. 1).
• the collar
Fitting the battery: Unscrew the 4 screws on the battery cover (cf. Diagram No. 2), insert
the battery (CR2) in the position indicated on the battery housing. A beep sound indicates
that the collar is switched on.
Check that the seal is in place in the groove of the battery cover.
Before re-tightening the 4 screws, force the strap against the battery cover by pulling it.
Using a screwdriver, moderately tighten the 4 screws.
switching off:
Ø
If the collar is not to be used for a long period, the battery should be removed from its
housing. If you want to take your dog off the property, you are advised to remove the
receiver collar. You can also switch the transmitter to Off and the green indicator light will
go out (cf. Diagram No. 1).
Antenna wire
Warning
By twisting the outward strand with the inward
beep area
strand, wave emission is blocked and the animal
can move freely within this zone.
Stimulation
area
Gb - 23
diagram no. 4:
sample installation
Transmitter unit
Twisted wire
2 m between
both wires