Direct Mode - Cameo ROOT PAR TW Manuel D'utilisation

STAND-ALONE MODE DIRECT
As with a DMX control device, stand-alone mode Direct makes it possible to directly set values from 000 to 255 on the device for the
dimmer, strobe, cold white, and warm white. This allows the user to create individual scenes without needing an additional DMX controller.
Starting from the main display, press MODE to go to the main menu. Using UP and DOWN, now select the Stand Alone menu option and
press ENTER to confirm. Use the UP and DOWN buttons again to select Direct , press ENTER to confirm, and then use UP and DOWN to
select the menu option you'd like to adjust. Confirm with ENTER. You can set the value as desired from 000 to 255 using UP and DOWN.
Then press ENTER to confirm all entries.
STAND-ALONE MODE CCT (Correlated Color Temperature)
The color temperature can be set in 100 K steps from 3100 K to 6500 K in the stand-alone CCT mode. The brightness and strobe effect can
also be configured.
Starting from the main display, press MODE to go to the main menu. Using UP and DOWN, now select the Stand Alone menu option and
press ENTER to confirm. Use the UP and DOWN buttons again to select CCT, press ENTER to confirm, and then use UP and DOWN to select
the menu option you'd like to adjust. Confirm with ENTER. Using UP and DOWN, select the desired value and then press ENTER to confirm
all entries.
STAND-ALONE MODE LOOP/SOUND
The stand-alone mode Loop makes it possible to individually design and reproduce a lighting sequence. Brightness, step time, fade time,
music control with microphone sensitivity, and delay (signal delay) can be set separately.
Starting from the main display, press MODE to go to the main menu. Using UP and DOWN, now select the Stand Alone menu option and
press ENTER to confirm. Use UP and DOWN again to select the desired Loop stand-alone mode and press ENTER to confirm your selection.
This will take you to the submenu for setting the submenu options (see table, use UP and DOWN to select, press ENTER to confirm, use UP
and DOWN to change status/value, press ENTER to confirm). The settings remain unchanged even once the device is restarted.
Loop Mode
Dimmer Adjusts the brightness
Steptime Adjusts the step time
Fadetime Adjusts the fade time in percent
Sound Deactivates (Off) or activates (On) music control
Sens Microphone sensitivity for music control
Delay Delay time for slave groups

Direct Mode

Dimmer Brightness
Strobe Strobe effect
Cold White Cold white
Warm White Warm white
CCT Mode
Dimmer Brightness
Strobe Strobe effect
CCT Correlated color
temperature
0–255
0–5 = deactivated
6–255 = approx. 1 Hz–20 Hz
0–255
0–255
0–255
0–5 = deactivated
6–255 = approx. 1 Hz–20 Hz
3100 K–6500 K
0–100
0.1 sec. to 10.0 sec.
0%–100%
Off/On
0–100
0.0 sec. to 2.0 sec.
9