Cameo ROOT PAR TW Manuel D'utilisation page 8

DMX DELAY
The DMX Delay function allows a chaser light effect to be easily created with any number of spotlights of the same model and software
version, which could otherwise only be achieved with a suitable DMX controller and complex programming. All spotlights integrated into the
setup are set to the same DMX mode and controlled with the same DMX start address.
On the one hand, the delay time (delay time of DMX signal) can be set manually on each spotlight with a different delay time (DMX Delay by
DMX? No). On the other hand, the connected DMX controller on a specially reserved DMX channel can be used to set the same delay time
for all spotlights (DMX Delay by DMX? Yes).
Starting from the main display, press MODE to go to the main menu. Using UP and DOWN, now select the DMX Delay menu option and
press ENTER to confirm your selection. Use the UP and DOWN buttons again to select the desired submenu option, press ENTER to confirm,
and set the value or status as desired. Press ENTER to confirm all entries.
Assign the spotlight to one of 95 groups (maximum number of groups depending on the activated DMX mode). Several spotlights can also
be assigned to one group. The group number is also the factor by which the set delay time is multiplied (see setup examples).
8