Cameo ROOT PAR TW Manuel D'utilisation page 11

SYSTEM SETTINGS (Settings)
Starting from the main display, press MODE to go to the main menu. Using UP and DOWN, now select the Settings menu option and press
ENTER to confirm.
This will take you to the submenu for setting the submenu options (see table, use UP and DOWN to select, press ENTER to confirm, use UP
and DOWN to change status/value, press ENTER to confirm).
Settings
Disp Rev = Rotates display
Disp Back = Display backlight
Sig Fail = Operating status if control
signal
is lost
IR Remote = Activates or deactivates
control via
IR remote control
PWM = LED PWM Frequency
Calibration = Color calibration
Reset = Resets
settings
Edit Preset = Saves all system settings
in three
individual presets
Service = Only for servicing purposes
No Display does not rotate
Yes Display rotates 180° (e.g., for overhead installation)
Off Deactivates after approx. 30 seconds of inactivity
On Permanently on
Hold Last command is held
Black Activates blackout
Dir Setting in stand-alone mode Direct is activated
On Activates control via the IR remote
Off Deactivates control via the IR remote
650 Hz, 1530 Selects the LED PWM frequency
Hz, 2150 Hz,
4000 Hz
Cold White Individual adjustment of brightness from cold white and
warm white with values from 0 to 255 (independent of
Warm White
mode)
Factory Resets to factory settings: Press ENTER to reset, MENU to
cancel
Preset A Resets to Preset A: Press ENTER to reset, MENU to cancel
Preset B Resets to Preset B: Press ENTER to reset, MENU to cancel
Preset C Resets to Preset C: Press ENTER to reset, MENU to cancel
Preset A Press ENTER to save
Preset B Press ENTER to save
Preset C Press ENTER to save
11