Walther Spritz- Und Lackiersysteme Gmbh Kärntner Str; D- 42327 Wuppertal; Ga 9010 Marking; Ga 9010 Marking-Membrane (Mb) V - WALTHER PILOT GA 9010 Manuel D'utilisation Original

Table of contents
Exploded view
Dimension sheet
Declaration of conformity
Spare parts list
Air cap/nozzle identification
1 General
1.1 Identification
1.1.1 Model identification
1.1.2 Explosion protection identification
1.2 Intended use
1.3 Inappropriate use
2 Technical description
3 Safety instructions
3.1 Identification of safety instructions
3.2 General safety instructions
4 Assembly
4.1 Mounting the spray gun
4.2 Supply line connection
5 Operation
5.1 Start-up and shut-down
5.2 Generating a spray pattern test
5.3 Correcting spray pattern flaws
5.4 Converting the spray gun
6 Cleaning
6.1 Safety instructions
6.2 Basic cleaning
6.3 Routine cleaning
7 Repair
7.1 Replacing a leaking needle seal
7.2 Replacing the material nozzle, needle, springs and seals
8 Troubleshooting and fault rectification
9 Disposal
10 Technical data
2
4
29
30
32
34
34
34
34
34
36
36
36
36
36
37
37
38
38
38
39
40
41
42
42
42
43
44
44
44
45
45
46
28
EC/EU Declaration of Conformity
We, the manufacturers of the device, hereby declare under our sole responsibility that
the product described below conforms to essential health and safety requirements. In
the event of changes to the device not agreed on with us or if used improperly, this
declaration becomes invalid.
Manufacturer Walther Spritz- und Lackiersysteme GmbH
Kärntner Str. 18 - 30
D - 42327 Wuppertal
Tel.: +49 202 / 787 - 0
Fax: +49 202 / 787 - 2217
www.walther-pilot.de • e-mail: info@walther-pilot.de
Type designation Automatic marking spray gun

GA 9010 Marking

GA 9010 Marking Membrane (MB)
Intended purpose Processing of sprayable materials
Applied standards and directives
EU-Mechanical Engineering Directives 2006/42/EC
2014/34/EU (ATEX Directives)
DIN EN ISO 12100:2011-3
DIN EN 1953:2013
Specification according to Directive 2014/34/EU
Category 2 Part marking
Authorised with the compilation of the technical file:

Nico Kowalski, WALTHER Spritz- und Lackiersysteme GmbH, Kärntner Str. 18 - 30

D- 42327 Wuppertal

Special remarks:
The product is intended for installation in other equipment. Commissioning is prohibi-
ted until such time as the end product has been proved to conform to the Directive
2006/42/EC.
Wuppertal, 31 January 2020
p.p.
Name: Torsten Bröker
Position in the company: Head of Design and Development
This declaration does not give assurance of properties within the context of product liability.
The safety instructions provided in the product documentation must be observed.
V 21 300 XX XXX
V 21 321 XX XXX
DIN EN 1127-1:2019
DIN EN ISO 80079-36:2016
Tech.File,Ref.:
II 2G X
2421
29