Invisible Zipper Foot; Lining - Brother PQ1300 Manuel D'utilisation

Invisible Zipper Foot

1 Attach invisible zipper foot.
2 Alight zipper with fabric. Mark the
base of the opening approximately
2 cm above the end of the zipper.
3 Fold the area to be sewed.
4 Line up zipper with fabric on the
wrong side of the fabric, open
zipper, and baste zipper to the
fabric.
5 Sew the zipper to the fabric with
the wrong side of the zipper and
fabric up.
When sewing with the teeth to
the right, the left side of the foot
should line up with the left teeth
of the zipper.
20 16
Teeth
Base of
Slide
Opening
2cm
Basting

Lining

1 Raise needle and foot.
2 Move separater so it sits under
presser foot.
3 Make sure it is lined up so that
the needle passes through the
slot of the separater without
hitting the plate itself.
4 Secure liner plate in place with
lining plate screws.
5 Set pressure of sewing feet and
feed position to pin feeding
position.
6 Pull thread until lower needle
catches fabric.
Sew 2-3 reinforcement stitches.
7 When not using separater, it can
be swung off to the side as
illustrated in drawing.
Needle
Separater
Separater
Needle
Lining
Separater
Velvets