Basic Sewing; Pin Feeding (For Hard-To-Handle Fabrics); Pin Feeding Unit - Brother PQ1300 Manuel D'utilisation

Basic Sewing (1)

Basic Sewing
Before
Begin
sewing.
sewing.
1 Lift foot, pull about 15cm of upper 2 Lower foot.
and bobbin thread under and behind
3 While needle is pierced all the way
foot, and position fabric under foot.

Pin Feeding (for hard-to-handle fabrics)

Fabric:
Velvet
Synthetic Suede
Others
1 Move feed adjustment knob
The above fabrics
c a n b e s e w e d to pin feeding position.
neatly by sewing
by pin feeding.
Finish
Sewing.
4 Raise needle to highest position.
5 Lift foot, remove fabric and cut
through fabric, step gently on foot thread.
controller.
When using thread trimmer:
4 Push thread trimmer button (this will
cause the upper and bobbin threads
to be cut automatically and the
needle to stop in a raised position.)
5 Lift presser foot and remove fabric.
Indicator Needle
N
2 Adjust pressure adjust- 3 Gently pull thread until feed pin
ment dial until indicator catches fabric and sew.
needle is in the right posi-
tion.
When changing sewing directions.
1 Make sure needle is pierced all the
way through fabric.
2 Lift presser foot, and turn fabric using
needle as an axis.
3 Lower foot and continue sewing.

Pin Feeding Unit

Feed Pin
The feed pin passes up through all layers of fabric moving with the feed dog's motion
to feed all layers of the fabric evenly.
Feed pin is automatically lowered when presser foot is raised.
Reinforcement stitches
1cm
1cm
At the beginning of a seam, sew a
few stitches with the hand wheel, hit
the reverse stitch button and sew a
few stitches back to reinforce your
seam, then go back to normal sewing
and finish the seam. Do the same at
the end of a seam.
Fabric
Feed Dog
Feed Pin
13