Bobbin Insertion - Brother PQ1300 Manuel D'utilisation

6 While holding the end of the thread,
step on the foot controller for a few
seconds. Once enough thread has
wound itself around the bobbin to hold
itself in place, release the foot
controller and trim the excess thread.

Bobbin Insertion

Slide Plate
Bobbin Door
1 Lift slide plate (and open bobbin
door).
8 12
7 Stop winding when bobbin is full.
Take foot of foot controller.
CAUTION – Moving parts –
To reduce risk of injury, switch off before servicing. Replace cover.
Latch Spring
Thread Notch
Bobbin should be
positioned so it
winds to the left
2 Put bobbin into the bobbin case.
Run thread through thread notch and
under latch spring, so that a length of
about 10 centimeters is exposed.
Bobbin Stop
8 Manually move bobbin stop back to
original position.
3 Pull the latch lever of the bobbin case
out and push the bobbin case into the
shuttle race and release the latch lever.
If the latch lever is not all the way on
the hook, it may fly off during sewing
and cause lower thread breakage.
9 Cut thread and remove bobbin.
4 Lower slide plate and close bobbin
door.