Upper Threading; Using The Automatic Needle Threader - Brother PQ1300 Manuel D'utilisation

Threading (2)
Note
Please turn power is off before using automatic needle threader. Accidentally stepping on the foot controller during this operation could cause bodily injury or damage to the machine.

Upper Threading

7
8
5
9
0

Using the Automatic Needle Threader

Automatic
Needle
Threader
1 Pull hand wheel towards you until
needle is in the highest position, and
lower presser foot.
2 Take thread in your left hand, and
gently pull it forwards.
1
6
2
4
3
Make sure thread take-up lever
is in highest position and presser
A
foot is up.
When using polyester, you
should run the thread through all
three holes of the thread guide.
Hook
Pin
3 Lower automatic needle threader.
Pull thread along the right side of the
pin.
1
6
2
4
5
4 Catch thread with hook.
Pull thread to the right, and make
sure it has been caught with the
hook.
7
3
8
If the thread is still
twisted, run the
thread through the
holes backwards as
shown in diagram.
5 Raise needle threader lever while
gently holding the end of the thread.
9
0
A
9