Changing Needles And Light Bulb; Changing The Needle; Changing Feed Pin; Changing Light Bulbs - Brother PQ1300 Manuel D'utilisation

Changing Needles and Light Bulb

Note
Please make sure power is off before carrying out
the following operations. There is a chance of
injury if the machine accidentally starts running
during this operation.

Changing the Needle

1 Turn the sewing machine
off. Raise needle to
highest position using
hand wheel, and lower
presser foot.
2 Loosen screw with screw-
driver, and remove needle.
3 Insert new needle, and
tighten screw. Make
sure needle is screwed
in tightly.
Check needles on a flat
surface to make sure
they're not bent.
Note
HLX5 needles should be uses; however, Schmetz
130/705H may also be used under normal
10 6
circumstances.
Changing the Feed Pin
1 Set the feed dogs to "velvet"
position. (see Page 5)
2 Remove needle, presser
foot and needle plate.
3 Lower presser foot and
turn hand wheel until feed
pin is in its highest position.
4 Insert small screwdriver
(included) as shown in diagram.
Screwdriver
5 While holding spring
with fingertip, lower the
feed pin changer onto
the needle to pick it up.
The needle should lay
parallel to a surface.
6 Attach new feed pin to
flat surface
feed pin changer, lower
and attach while holding
Lay needle on a
spring with fingertip.
flat surface
7 Remove screwdriver.
(such as the needle
plate or a plate
8 Re-attach needle plate,
of glass).
needle and presser foot.
Note
Please make sure power is off before carrying out
the following operation. The glass plate over the
light bulb will be hot immediately after using the
machine, so you should wait until the machine has
had a chance to cool down before changing bulbs.

Changing Light Bulbs

1 Turn off power.
Screwdriver
2 Remove screws from
head.
3 Remove head.
4 Unscrew bulb and remove.
5 Screw in new bulb.
Rated 120V 15W
6 Re-attach head and
tighten screw.
Light
Bulb