Starting Up; Program Variants - Gram KP 660 Mode D'emploi

Starting up

P
P
Temperature regulation
Time setting
Chilling temperature
Storage temperature
Press the main switch
The figures now displayed give the actual temperature in the cabinet and at the same
time confirm that power is on.
The cabinet is now ready for programming and/or starting up. See section on
programming and program sequence.
NOTE:
1. Servicing
Make sure the appliance is switched off at the socket before service is performed
on electrical parts. It is not sufficient to switch off the cabinet by the ON/OFF key
as there will still be voltage to some electrical parts of the cabinet.
2. Starting up in tropical conditions
When starting the appliance in an ambient temperature of around 40°C or higher,
the display will show sensor fault F1 - F2 (because the sensor cannot register
temperatures higher than 40°C).
About 10 - 15 minutes after compressor start, the actual temperature will be shown
in the display (when the temperature has fallen to under 40°C).

Program variants

The cabinet offers the following program possibilities:
1: Storage program.
2: Time-controlled chilling.
3: Temperature-controlled chilling.
4: Combination of time and temperature-controlled chilling.
76-504-0981
to start.
Arrow key up
Arrow key down
Main switch
19