Location; Electrical Connection - Gram KP 660 Mode D'emploi

ENGLISH

Location

The cabinet should be placed in a dry and adequately ventilated room. To ensure
effective operation, do not place it in direct sunlight or near a heat source. The
cabinet is designed to operate in an ambient temperature of up to +40°C. If the
cabinet is a version with legs, the adjustment screws on the legs can be used to
make sure the cabinet stands level.

Electrical connection

The cabinet is intended for connection to alternating current. The connection values
for voltage (V) and frequency (Hz) are given on the nameplate inside the cabinet.
Power must be connected via a wall socket with switch. The wall socket should be
easily accessible.
All earthing requirements stipulated by local electricity authorities must be observed.
The cabinet plug and wall socket should then give correct earthing. If in doubt,
contact your local supplier or an authorised electrician.
WARNING - THIS APPLIANCE MUST BE EARTHED
The flexible cord fitted to this appliance has three cores for use with a 3-pin 13-amp
or 3-pin 15-amp plug. If a BS 1363 (13-amp) fused plug is used, it should be fitted
with a 13-amp fuse.
IMPORTANT
The wires in this mains lead are coloured in accordance with the folowing code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
The colours of the wires in the mains lead of this appliance might not correspond with
the colour markings identifying the terminals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW wire to the plug terminal marked by "E" or by an
earth symbol, or coloured GREEN or GREEN-AND-YELLOW.
Conect the BLUE wire to the plug terminal marked "N" or coloured BLACK.
Connect the BROWN wire to the plug terminal marled "L" or coloured RED.
76-504-0981 18