Power Failure; Cleaning; Servicing (And Nameplate) - Gram KP 660 Mode D'emploi

Power failure

If the power fails, the control will remember the settings.
When power is restored, the cabinet will always start up on the storage program,
irrespective of whether the time and/or chilling program was active prior to the power
failure.

Cleaning

NB!: Always disconnect the cabinet before cleaning.
The cabinet should be cleaned internally with a mild soap solution at suitable
intervals and checked thoroughly before it is put into operation again.
For the external maintenance – use stainless steel polish.
Cleansing agents containing chlorine or compounds of chlorine as well as other
corrosive means, are not to be used, as they might cause corrosion to the stainless
panels inside the cabinet and the evaporator system.
The compressor compartment and in particular the condenser must be kept free from
dust and dirt. This is best done with a vacuum cleaner and a brush.
The air filters on the condenser and the front panel can be removed and cleaned in a
dishwasher at max. 50°C.
Do not flush compressor compartment and evaporator with water as this may cause
short-circuits in the electrical system.
Servicing
The refrigerating system and the hermetically-sealed compressor need no inspection
- only cleaning. The panel screen cover can be removed by pushing it upwards. If
refrigeration fails in some way, first check to make sure the power has not
inadvertently been switched off and then check the house fuses. If the cause of the
failure cannot be found, contact your supplier. Give the type name and part number.
TYPE, SER.NO. and PART NO. are given on the nameplate on the inside of the side
panel.
Nameplate
76-504-0981 26