Keylock; Defrosting; Defrost Water; Light Source Replacement - Gram Roll-in 1500 Mode D'emploi

Keylock

The keypad can be locked by keying the code: 123P (default setting).
indicate that the keys are locked, and a short beep sounds. Now it is not possible to use
the keys for temperature setting etc.
The same code is to be used for unlocking the keypad again.

Defrosting

Defrosting is automatically performed twice every 24 hours. If the cabinet is operating
under severe load (frequent door opening and frequent replenishment) manual defrosting
can become necessary. The cabinet can be manually defrosted by switching it off and on.
It will then start to defrost. The next defrost will occur 12 hours later.
a defrosting cycle.
Do not use sharp or pointed objects to
accelerate the defrosting process.

Defrost water

Defrost water is led through a tube in the insulation, to a tray on the back of the
cabinet.
A re-evaporation pipe from the refrigeration system, placed in the tray, evaporates the
defrost water.
The tray should be regularly cleaned (minimum once a year).

Light source replacement

The light bulb may only be replaced by authorized persons.

Power failure

In the event of a power failure, the control remembers the temperature setting and restarts
the cabinet when power is restored. If the power failure persists for some time, the control
might revert to the factory setting.

Cleaning

Always disconnect the cabinet before cleaning.
Do not flush compressor compartment and evaporator with water as this may cause short-
circuits in the electrical system.
765041114
lights to
lights up to indicate
19