Connecting The Cabinet; Starting Up - Gram Compact 210 Mode D'emploi

Connecting the cabinet

Read the text below thoroughly before electrical connection.
The cabinet is intended for connection to alternating current. The connection voltage (V)
and frequency (Hz) are shown on the name plate in the cabinet .
Power connection is made by a three pin plug to a wall socket.
Do not use the cabinet before all shieldings have been mounted to prevent access to live
or rotating machine parts.
Do not use the cabinet, if the wire has been damaged. In this case the cabinet must be
examined by a service electrician from Gram Commercial or an authorised refrigeration
company with knowledge of Gram's products.
The cabinet must not be used outdoor. All earthing requirements stipulated by the local
electricity authorities must be observed. The cabinet plug and wall socket should then give
correct earthing. If necessary, contact an electrician.

Starting up

Display:
Connect the cabinet to main power.
To turn on the cabinet, push
The display shows the actual cabinet temperature, and indicates that power is connected.
The cabinet is turned off likewise, by pushing
Display
Evaporator fan
Defrost
Alarm Compressor
for 2 seconds.
- key + key
P key
°C
°F
for 2 seconds.
on/off
17