Reversing The Door; Cleaning - Gram Compact 210 Mode D'emploi

Reversing the door

The door can be changed from righthand-hinged to lefthand-hinged, or vice versa.
To do so, proceed as follows:
Models with solid door:
C
D
Models with glass door:
The door should only be reversed by a service electrician from Gram Commercial or an
authorised refrigeration company with knowledge of Gram's products.

Cleaning

Before cleaning, switch off the cabinet at the mains.
The cabinet should be kept clean using a mild soap solution. Do not use cleaning
detergents that may cause scratches.
When regular cleaning is carried out, be sure to wipe clean the rubber door gasket to
ensure any sticky substances are removed which would otherwise damage the gasket.
The condenser on the back of the cabinet must be regularly cleaned as well. This is best
done with a vacuum cleaner and a brush.
A
1. Switch off the power at the
mains socket.
2. Dismantle the two screws that
hold the control panel at front
and back, pull the panel a little
forward, and then tilt it upwards.
3. Dismantle the hinge at pos. A,
and lift off the door.
4. Dismantle the hinge at pos. B,
and mount it at pos. D.
5. Turn the door 180°, and fix it at
the hinge pos. D.
6. Mount the hinge from pos. A in
pos. C, and move bracket from
pos. C to pos. A.
7. Fasten the control panel again.
B
Apply power to the cabinet
again.
22