Variable Speed - Ryobi CHD-1442 Manuel D'utilisation

GB
F D
OPERATION
Connect charger to power supply.
■
Place battery pack in charger. Align raised rib on
■
battery pack with groove in charger.
Press down on battery pack to be sure contacts on
■
battery pack engage properly with contacts in charger.
When properly connected, red light will turn on.
When your battery pack becomes fully charged, the
■
red light will turn off and the green light will turn on.
After normal usage, 1 hour of charge time is required
■
to be fully charged. A minimum charge time of 1 to
1-1/2 hours is required to recharge a completely
discharged tool.
DO NOT place charger in an area of extreme heat
■
or cold. It will work best at temperatures above 10°C
and below 38°C
IMPORTANT INFORMATION FOR RECHARGING HOT
BATTERIES
When using your tool continuously, the batteries in your
battery pack will become hot. You should let a hot battery
pack cool down for approximately 30 minutes before
attempting to recharge.
TO INSTALL BATTERY PACK (Fig.2)
Place the direction of rotation selector in center
■
position.
Place the battery pack in the tool. Align raised rib on
■
battery pack with groove in the tool's battery port.
Make sure the latches on each side of the battery
■
pack snap in place and that battery pack is secured in
the tool before beginning operation.
TO REMOVE BATTERY PACK (Fig.2)
Place the direction of rotation selector in center
■
position.
Locate latches on side of battery pack and depress
■
both sides to release battery pack.
Remove battery pack from the tool.
■
SWITCH TRIGGER (Fig.3)
To turn the drill ON, depress the switch trigger.
■
To turn it OFF, release the switch trigger.
■
E I P NL S DK N FIN GR
English

VARIABLE SPEED

The variable speed switch trigger delivers higher speed
and torque with increased trigger pressure and lower
speed with decreased trigger pressure.
SWITCH LOCK (Fig. 3)
The switch trigger can be locked in the OFF position.
This feature can be used to prevent the possibility of
accidental starting when not in use. To lock switch trigger,
place the direction of rotation selector (Forward/Reverse
Selector) in center position.
Note: When selector is in center position, switch trigger
is locked.
REVERSIBLE (Fig. 3)
The direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With the
drill held in normal operating position, the direction of
rotation selector should be positioned to the left of the
switch trigger for drilling. The drilling direction is reversed
when the selector is to the right of the switch trigger. To
stop the drill, release the switch trigger and allow the
chuck to come to a complete stop.
ADJUSTING THE SPEED (Fig. 4)
Follow these steps to adjust the speed.
For high speed: Slide the two-speed gear train switch
■
to "2".
For low speed: Slide the two-speed gear train switch
■
to "1".
Note: If you have difficulty changing from one gear
range to the other, turn the chuck by hand until the gears
engage.
QUICK MODE SELECTOR (CHD-1442/CHP-
1802 Fig.5 / CHI-1442/CHI-1802 Fig.6)
The Quick Mode Selector allows you to quickly switch
from drill mode to drive mode.
In general, drill mode should be used for drilling and
other heavy duty applications. Drive mode should be
used for driving screws. Impact mode should be used for
impact drilling.
11
H CZ RUS RO
CAUTION
To prevent gear damage, always allow chuck to
come to a complete stop before changing the
speed or the direction of rotation.
PL SLO HR TR