Changing The Temperature - GE 21 Série Manuel D'utilisation

About the controls with temperature settings.
H
OME
F
REEZER
0
H
ELP
P
RECISE
L
OCK
Hold for 3 Seconds
to activate Lock
NOTE: The refrigerator is shipped with protective film covering the temperature controls.
If this film was not removed during installation, remove it now.
The temperature controls are preset in the factory at 37°F for the refrigerator
compartment and 0°F for the freezer compartment. Allow 24 hours for the temperature
to stabilize to the preset recommended settings.
The temperature controls can display both the SET temperature as well as the actual
temperature in the refrigerator and freezer. The actual temperature may vary slightly
from the SET temperature based on usage and operating environment.
Setting either or both controls to OFF stops cooling in both the freezer and refrigerator
compartments, but does not shut off electrical power to the refrigerator.

Changing the Temperature

For Controls-on-the-Door Models:
Models with External Dispensers:
To change the Refrigerator temperature:
Access By: Home > Refrigerator
Activate By: Using the arrows to select the desired
temperature. You must press ENTER to set the new
temperature.
To change the Freezer temperature:
Access By: Home > Freezer
Activate By: Using the arrows to select the desired
temperature. You must press ENTER to set the new
temperature.
Once the desired temperature has been set, the display will
return to the HOME screen and show the set temperatures
underneath the actual temperature display for several
seconds. Several adjustments may be required. Each time
you adjust the controls, allow 24 hours for the refrigerator
to reach the temperature you have set.
For Controls Inside the Refrigerator:
Opening the door displays the actual temperature. To
change the temperature, press either the WARMER or
COLDER touch pads until the desired temperature is
4
displayed.
(Models with controls inside the refrigerator)
E S ON
NERGY AVER
R
EFRIGERATOR
F 37 F
F O
ILL PTIONS
(Models with controls on the door)
T
URBO
C
OOL
E
NERGY
S
AVER
D
OOR
A
LARM
Once the desired temperature has been set, the
temperature display will return to the actual refrigerator
and freezer temperatures after 5 seconds. Several
adjustments may be required.
Each time you adjust controls, allow 24 hours for the
refrigerator to reach the temperature you have set.
To turn the cooling system off, tap the WARMER pad for
either the refrigerator or the freezer until the display shows
OFF. To turn the unit back on, press the COLDER pad for
either the refrigerator or freezer. Then press the COLDER
pad again and it will go to the preset points of 0°F for the
freezer and 37°F for the refrigerator. Setting either or both
controls to OFF stops cooling in both the freezer and
refrigerator compartments, but does not shut off electrical
power to the refrigerator.
Models with External Dispensers:
Access By: Home > Options > Information and Settings >
Cooling System Off
To turn the cooling system back on, press the touch screen
and press the ON button.
Activate By: Pressing ENTER.