GE 21 Série Manuel D'utilisation page 10

About the freezer.
Not all features are on all models.
Appearance and features may vary
Appearance may vary
Tab
Pins
10
Freezer Shelves and Baskets
A full-width upper basket in top drawer
Ice bucket
A deep full-width lower basket with
the divider in the bottom drawer
Basket Removal (Top Drawer)
To remove the full-width basket:
Open the top freezer drawer until it stops.
The freezer basket rests on the inside
tabs on the drawer slides.
Lift the front end of the basket so that the
front two alignment tabs come out of the
metal slide brackets first. Then rotate the
front edge of the basket up while lifting
the remaining two rear alignment tabs
out of the metal slide brackets.
Make sure the plastic sleeves remain
attached to the 4 slots on the metal slide
brackets.
Basket Removal (Bottom Drawer)
The Bottom Drawer basket is a 2-piece
basket.
To remove the 2-piece basket:
Open the bottom freezer drawer until
it stops.
Pull the divider forward until the rear
locating tabs are out of the slots. Turn the
divider slightly to the side to release the
front locating tabs and lift out.
The freezer basket rests on the metal
slide brackets and is held in place with
swing locks.
Turn the swing locks from horizontal to
vertical position.
Lift the front portion of the basket up,
rotate it toward you, and bring it straight
up to remove.
Lift the back portion of the basket up and
out of the drawer.
When replacing the full-width basket:
Tilt the basket back and lower it down into
the drawer. Rotate the basket to a horizontal
position and press it down into the slots.
NOTE: Always be sure that all 4 basket tabs
are engaged in the metal slide brackets
before sliding back into the freezer.
When replacing the 2-piece basket:
Place the rear of the basket onto the
metal slide brackets. There will be 2 pins
on each underside of the back that will
align for securing the basket.
Seat the front of the basket onto
the metal slide brackets and over the
swing locks.
Turn the swing locks from vertical to
horizontal position to lock the basket
in place.
Turn the divider slightly to one side so
the tabs on the front fit into the vent slots
on the basket. Position the divider so the
back locating tabs snap into place in the
back vent slots.