EMAK TUAREG 92 EVO Manuel D'utilisation page 25

(10) MOWING DECK ELEVATION ADJUSTMENT LEVER
The lever serves to set the elevation height of the mowing deck from the ground.
When travelling without mowing the lever must be set to the transport position!
The mulching function can be improved by using a special accessory, a so-called „mulching
set", which is supplied separately as a special accessory for mowing maintained lawns.
(11) BY-PASS LEVER – FREE MOVEMENT OF THE REAR WHEELS
The by-pass lever serves to disengage the transmission for the rear wheel drive and is used to push or
pull the machine without using the engine. The lever is located on the rear side of the machine and has
the following two positions:
ATTENTION! On the AC 92-23 4x4 machine the lever is used primarily for bleeding the
hydrostatic system. Due to the high demands on equipment, have this procedure performed
by a specialised service centre.
The machine must not be used (gear shifted into drive) if the by-pass lever is in the
disengaged position - there is a danger of damage to the transmissions!
The lever has 4 work positions (50 - 60 - 75 – 100 mm), where the
corresponding mowing height is 5 to 10 cm. The higher the number
of the lever position, the higher vegetation height remains after
mowing.
There is also 1 transport position, which is 120 mm above the
ground. When the lever is set to the transport position it is not
possible to activate the mowing deck as a safety switch is built into
this position.
Position Rear wheel drive
(0) DISENGAGED
(1) ENGAGED
25
Use
Lever is extended - for pushing the
machine
Lever is inserted - for driving the
machine