Maintenance And Service; Maintenance And Cleaning; Accessories; After-Sales Service And Application Service - Bosch EXAConnecT II + Notice Originale

OBJ_BUCH-816-001.book Page 36 Wednesday, October 30, 2013 2:06 PM
36 | English
Code Error description
E5 A routine check of the file system during access point start-up has
detected an inconsistency in the flash memory. Only a reserve sys-
tem is running in order to display this message and to initiate coun-
termeasures.
Normal operation of the access point is not possible.
Note: All data stored (including the firmware) has been erased.
E6 The Bluetooth interface of the access point is not accessible or is
no longer accessible or the Bluetooth protocol stack reports unex-
pected errors.
E7 The operating software of the access point had an internal excep-
tion error (exception).
E8 Wrong firmware version:
The operating software (firmware) of the access point is the wrong
version (e.g. V1.9.x on an EXAConnecT II).
P<N> The screwdriver having the internal index N has responded via the
BT interface with an incorrect format or has not responded at all.
Log-specific errors
Log-specific errors refer to the respective database log,
whereby the error codes can be individually adapted to this
log.
These error codes can have different meanings depending on
the log.

Maintenance and Service

Maintenance and Cleaning

 Disconnect the access point both from the power sup-
ply and from the PC when you perform cleaning work.
In this way, you prevent the danger of electric shock.
 Check that the seal ring 36 is correctly seated when
you remove the service and maintenance cover plates.
Replace any damaged seal rings. Only when the seal ring
is sitting correctly in the recess will it ensure dust and
moisture resistance when the housing is closed.
Clean the connection sockets and the housing of the access
point with a dry, lint-free cloth after it has been disconnected
from the power supply, and remove dust and dirt particles.
 Have maintenance and repair work performed only by
qualified specialists. This will ensure that the safety of
the access point and I/O module is maintained.
An authorized Bosch after-sales service agent will carry out
this work quickly and reliably.

Accessories

For more information on the complete quality accessories
program, please refer to the Internet under
www.bosch-pt.com or contact your specialist shop.
3 609 929 C48 | (30.10.13)
Corrective Measure
Reformat the flash memory.
Contact the manufacturer if the error continues to
occur.
Restart the access point.
Contact the manufacturer if the error continues to
occur.
Restart the access point.
Contact the manufacturer if the error continues to
occur.
Install (flash) the correct firmware (V2.x) onto the
access point.
Replace the rechargeable battery of the screwdriver
or replace the screwdriver itself.
Contact the manufacturer if the error continues to
occur.

After-sales Service and Application Service

In all correspondence and spare parts orders, please always
include the 10-digit article number given on the nameplate of
the product.
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Bosch's application service team will gladly answer questions
concerning our products and their accessories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: (0844) 7360109
Fax: (0844) 7360146
E-Mail: boschservicecentre@bosch.com
Bosch Power Tools