Cleaning And Maintenance; What If There Are Problems - Beurer BF 720 Mode D'emploi

NOTE:
• When replacing the batteries, use batteries of the same type, make and capacity.
• Do not use rechargeable batteries.
• Use batteries free from heavy metals.

8. Cleaning and maintenance

The device should be cleaned from time to time.
This should be done using a damp cloth and, if necessary, a small amount of detergent.
IMPORTANT
• Never use abrasive solvents or cleaning products!
• Never submerge the device in water!
• Do not clean the device in a dishwasher!

9. What if there are problems?

If the scale encounters an error during measurement, the following is displayed:
Display
" "
BF-
or incorrect weight
is displayed.
or incorrect weight
is displayed.
Incorrect weight is dis-
played.
No Bluetooth con-
®
nection ( symbol is
missing).
Cause
Unknown measurement as it
is outside the user assignment
limit or a unique assignment is
not possible.
The proportion of fat is outside
the measurable range (less
than 3% or greater than 65%).
Maximum weight capacity of
180 kg exceeded.
No even, hard surface.
Not standing still.
Incorrect zero point of scale.
Device outside the range.
No connection to the app.
Solution
Select your user by pressing the / but-
tons.
Please repeat the measurement barefoot, or
with the soles of the feet lightly dampened
if necessary.
Loads must not exceed 180 kg.
Place the scale on an even, hard surface.
Stand as still as possible.
Wait until the scale switches itself off. Acti-
vate the scale, wait for "0.0 kg" to appear
and take the measurement again.
The minimum range in the open is approx.
10 m. Walls and ceilings reduce the range.
Other radio waves may interfere with the
transmission. Therefore, do not position the
scale near devices such as WiFi routers,
microwaves, induction hobs etc.
Completely close the app (including in the
background). Switch Bluetooth
back on again. When doing so, please note
that the scale must not be connected from
the Bluetooth settings of the operating sys-
tem. If need be, remove it from the devices
list in the Bluetooth settings, and then use
the "beurer HealthManager" app. Switch the
smartphone off and back on again. Remove
the batteries in the scale for a short period
and reinsert them.
24
off and
®