Ibanez AM53-SRF Mode D'emploi page 55

EDGE-ZERO2 TREMOLO BRIDGE
■
Overview
1
6
5
■
Rear 1
B
7
7
8
A
ATTACHING THE TREMOLO ARM
1 The tremolo arm employs a one-piece snap-in design with an adjustable-
torque cap. Insert the tremolo arm into the arm socket of the base plate.
2 Tighten the torque adjustment cap to secure the tremolo arm. The tremolo
arm will become tighter as you tighten the torque adjustment cap.
TREMOLO ANGLE ADJUSTMENT / ZERO POINT SYSTEM TREMOLO
ANGLE ADJUSTMENT / ZERO POINT SYSTEM ADJUSTMENT
・ Models not equipped with the zero point system
The tremolo attachment angle is adjusted by changing the balance between the string tension and the
tension of the tremolo springs installed on the back of the guitar body. Youʼll obtain the best performance by
adjusting the tremolo arm so that it is approximately parallel with the surface of the guitar body.
3
2
1
4
8
9
:
1 knife edge
2 saddle lock bolt
3 string holder block
4 tremolo arm socket
5 string stopper bolt
6 fi ne tuning bolt
7 main spring
8 sub spring
9 stopper
: stop rod
A tremolo block
B spring adjustment knob
C tremolo spring
D spring lock
■
Rear 2
C D
53