Ibanez AM53-SRF Mode D'emploi page 50

Memo
• Loosen the strings suffi ciently before you install or remove tremolo springs. Be aware that if you remove
all of the springs, the tremolo unit will detach from the guitar.
• To reattach the tremolo, insert the knife edge of the tremolo securely into the groove of the stud bolts,
and then install the tremolo springs.
STUD LOCK
The Edge/Lo-Pro Edge tremolo bridge uses a stud lock mechanism.
1 Insert an HEX key wrench (1.5 mm) through the hole in the top of the stud bolt.
2 Turn the stud lock bolt clockwise, tightening it until it contacts the anchor nut
and can no longer rotate.
The stud lock will be released when you loosen the stud lock bolt.
※
ADJUSTING THE ACTION
To adjust the height of the entire tremolo unit, use an HEX key wrench (4mm)
to turn the stud bolts located at the left and right of the tremolo unit. (It is not
possible to make adjustments for each string individually.)
Memo
• Make sure that the stud lock is released before you adjust the action.
ADJUSTING THE INTONATION
1 Use an HEX key wrench (3 mm) to loosen the pressure pad bolts of the locking
nut, and loosen the strings suffi ciently.
2 Use an HEX key wrench (2 mm) to loosen the saddle lock bolts, and adjust the
saddle position.
Before checking the intonation, fi rmly tighten the saddle lock bolts and
※
tune the guitar correctly. When youʼve fi nished making adjustments,
tighten the saddle lock bolts and the pressure pad bolts of the locking nut.
48