Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12 www.electrolux.com
If you touch
set the DURATION, the appliance
switches to the setting of the END
function.
6.
When the set time ends, an acoustic
signal sounds for two minutes.
and time setting flash in the dis-
play. The appliance deactivates.
Touch a sensor field to stop the
acoustic signal.
7.
Deactivate the appliance.
7.3 Setting the END
1.
Activate the appliance and set an
oven function and temperature.
2.
Touch
display shows
display.
3.
Use
you set the minutes and then the
hours) and
4.
When the set time ends, an acoustic
signal sounds for two minutes.
symbol and the time setting flash
in the display. The appliance deacti-
vates.
5.
Touch a sensor field to stop the
acoustic signal.
6.
Deactivate the appliance.
7.4 Check result (selected
models only)
If you set the END or DURATION function,
two minutes before the end of cooking an
acoustic signal sounds and the lamp acti-
vates. The appliance goes to the setting
of the END or DURATION function. During
these two minutes you can examine the
results of the cooking, and, if necessary,
add the END or DURATION time.
7.5 Setting the MINUTE
MINDER
Use the MINUTE MINDER to set a count-
down (maximum 23 h 59 min). This func-
or
while you
again and again until the
.
flashes in the
or
to set the END (first
or
to confirm.
tion has no effect on the operation of the
oven. You can set the MINUTE MINDER
at any time and also when the appliance
is off.
1.
Touch
.
and "00" flash in the
display.
2.
3.
Use
or
to set the MINUTE
MINDER. First you set the seconds,
then the minutes and the hours.
4.
Touch
or the MINUTE MINDER
starts automatically after five sec-
onds.
5.
When the set time ends, an acoustic
signal sounds for two minutes and
00:00 and
flash in the display.
6.
Touch a sensor field to stop the
acoustic signal.
7.6 Setting the Time delay
function
The DURATION
and END
can be used at the same time, if the oven
is to be activated and deactivated auto-
matically later. In this case, first set the
DURATION
and then the END
function (refer to "Setting the DURATION"
and "Setting the END ").
When the Time delay function is activated,
the display shows a static symbol of the
oven function,
with a dot and
dot shows which clock function is on in
the Clock / residual heat display.
functions
. The
Publicité
Chapitres
Table des Matières
