Safety Instructions For Maintenance; Regular Greasing; Possible Malfunctions - Bartscher 174.195 Mode D'emploi

6.3 Safety instructions for maintenance

o Check the mains connection cable for damage from time to time. Never operate the
device when the cable is damaged. A damaged cable must immediately be replaced
by customer service or a qualified electrician to avoid dangers.
o In case of damage or malfunction, please contact your stockist or our customer
service centre. Pay attention to the troubleshooting tips in pt. 7.
o Only a qualified technician and using original spare parts and accessories should
carry out repairs and maintenance of the device. Do not attempt to repair the
device yourself.

Regular greasing

o The carriage is to be greased regularly with
a natural technical grease. In order to do so
put the slicer on its side and grease both
ends of the carriage axle (i) (Fig. 14). Move
the carriage forward and backward in order
to distribute the grease evenly. Remove the
excess grease with a cloth.

7. Possible Malfunctions

Problem
The knife does not
cut or the slices are
fuzzy and/or
irregular.
Knife sharpening is
not satisfactory
The sharpener does
not work
Cause
• Knife is not sharp
• Knife is excessively worn
• Sharpener elements are
worn
• Position is incorrect
• Sharpener elements are
dirty
Solution
• Sharpen the knife
(5.3 Operating)
• Replace the knife
• Replace the sharpener
elements
• Install the sharpener
correctly (5.3 Operating)
• Clean the sharpener
elements
i
Fig. 14
- 39 -