Bartscher 174.195 Mode D'emploi page 39

Knife protecting device
o Loosen the screws (f) of the protective device
(g) on the back of the slicer, using appropriate
screwdriver. (Fig. 11).
o Wash the protective device (g) in warm water
with neutral cleaning agent. Rinse in clean
water. After cleaning dry it completely.
o Reinstall the protective device (g) on the
slicer and tighten screws (f).
Slice tray and housing
o Wash the slice tray (11) and housing with use
of moist, soft cloth and the neutral cleaning
agent, dry completely after cleaning.
Sharpener
o Remove the sharpener as a whole from the
device (fig. 6).
o After sharpening clean the sharpener elements
(h) with the cleaning brush soaked in alcohol
(fig. 13).
ATTENTION!
Never use the dishwashing machine for cleaning the removable elements.
o Never use chemical or corrosive cleaning agents.
o In order to avoid rust never clean the device with AkoPads or similar, or the wire
washcloth.
o Always use a soft cloth and never use coarse cleaning agents that could damage or
scratch the surface of the device.
o After cleaning operations wipe and polish the device with a dry cloth.
- 38 -
f
11
h
g
Fig. 11
Fig. 12
Fig. 13