Installation And Operation; Safety Instructions - Bartscher 174.195 Mode D'emploi

5. Installation and operation

5.1 Safety instructions

WARNING! Electrical hazard!
The device must only be connected to a properly installed single socket with
protective contact.
Never yank cord to disconnect from outlet.
Cable must not touch any hot parts.
•
See that the cable does not touch any heat sources or sharp edges. Do not let the
cable dangle over the counter edge.
•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the device
or personal injury, and further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable.
Keep away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
Protective elements
⑭
④
⑬
⑩
- 30 -
⑭
③
③
④
④
⑥
⑩
⑥
⑬
Fig. 3
Sharpener as the upper knife cover;
Knife cover;
Pusher handle;
Carriage locking device (models
174.220, 175.250, 174.275, 174.300 –
carriage adjustment, model 174.195 –
special bolt);
ON-/OFF button (in case of power
supply interruption the slicer may be
restarted only by pressing the white
START button again);
Pusher cover.