Operating; Before Use - Bartscher 174.195 Mode D'emploi

5.3 Operating

CAUTION!
The device can only be used by a qualified operator who is aware of safety issues
mentioned in this manual.

Before use

•
Clean the device before use (see chapter 6.2 "Cleaning").
•
Before start check the following aspects (fig. 4):
⑫
④
⑩
⑧
Device operation (figs. 4, 5)
•
Connect the device to the grounded, single socket.
•
Turn the device on by pressing the START button (10). Leave the device on for
2-3 minutes in order to make sure it operates correctly. Turn the device off by
pressing the STOP button (10).
•
Set the slice thickness adjustment (8) in position "0".
•
Lift the pusher handle (4) and put the sliced product on the food carriage tray (5) so
that it will be between the movable slice thickness wall (12) and the pusher handle (4).
WARNING! Possible cuts danger!
In order to avoid accidents, always use the pusher handle (4) to push the sliced
product to the cut thickness movable wall (12)!
- 32 -
⑭
- connection of the device to the grounded, single
①
- adjustment of the carriage with use of carriage
- carriage motion (7), no obstacles for its motion
⑤
- lifting and lowering of the pusher handle (4)
- hole of the cut thickness movable wall (12) with
⑦
- correct fixing of the sharpener (14) and possibility
⑥
Fig. 4
socket;
adjustment;
and no objects on its tray (5);
without any obstacles;
the slice thickness adjustment (8), rotating it
clockwise and counterclockwise;
of removing it without any problems.