Installation And Connection - Bartscher 174.195 Mode D'emploi

WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of
the device and make sure it cannot tilt at any time.
•
Place the device at height of approx. 80 cm.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
Put the device in a room with maximum 70% moisture level, where the temperature
ranges from +5° C do +32° C.
•
Leave space around the device and keep away from other devices and equipment
in order to ensure the correct operations of the slicer.
•
Put the slicer in such a way that the person operating it could stand straight and
stable in front of the device. The operator has to constantly be able to see the slice
adjustment and the off button.
•
Always keep the workplace clean and tidy.
•
The power supply circuit with the socket must be protected by the fuse at least 16A.
Connect the device directly to the wall socket; do not use any extension sockets.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.
- 31 -