General Cleaning And Maintenance - Sagi KP8G Manuel D'utilisation Et D'installation

WARNING: respect for this point is very important to insure the necessary stability of the shelf.
•
To unhook the shelf follow the previous directions in reverse order.
Check and verify that the line voltage corresponds to that found on the technical specifications plaque on the
unit. The manufacturer recommends that a sole use circuit be dedicated for the unit.
WARNING: An omnipolar switch is to be installed before the appliance, in compliance with the current
regulations applied in the country where the appliance is installed
Also recommended to install a differential switch.
Then insert the plug into the current tap.
Now the installation has come to end.

GENERAL CLEANING AND MAINTENANCE

For regular and constant service of the unit it would be well to regularly carry out general cleaning and
maintenance operations.
WARNING: The cleaning and maintenance of the refrigerating engine and the compressor area needs the
intervention of a skilled technician, therefore it cannot be done by other persons.
The air condenser should be kept clean to ensure the device performance and efficiency, as air should
circulate inside the device without barrier.
WARNING: The condenser should therefore be cleaned every 30 days or as needed
A dirty Condenser can result in NON-WARRANTEED part & Compressor Failures, Product Loss.
Before to begin with the operations proceed as following:
- set the general cut-out in OFF position;
- remove the plug from the socket and wait till the complete entfrosting of the unit.
To access the condenser it is necessary to remove the front dashboard:
1. Remove the lower instrument panel, grasping it on the side, freeing it from the four retaining bolts
2. Remove the cable from the panel control board
9