Sagi KP8G Manuel D'utilisation Et D'installation page 102

Press and release the key on/sby/enter: the current setpoint blinks on the display for
5 seconds.
After 5 seconds, the displays shows the room temperature again
While the display is blinking, use the up and down keys to increase or decrease the
temperature setpoint
Press the on/sby/enter button again to confirm the new set point
Forced manual defrost
Push the up button, hold down for more than 3 seconds to access the manual defrost
functions.
Change in relative humidity +2°C/+10°C and -22°C/+5°C
Push the down button, hold down for more than 3 seconds to modify the percentage
of relative humidity in the chamber.
The temporary flashing confirmation label [F_C] corresponds to a too low relative
humidity (fans in parallel with the compressor).
The flashing temporary confirmation label [F_ _] corresponds to a too high relative
humidity (fans independent).
The relative humidity that blinks on the temporary label [FtE] is programmed by the
manufacturer.
Change in relative humidity +14°C/+16°C
Push the down button and hold down for more than 3 seconds: the display visualises
the current humidity setpoint for 5 seconds in a flashing modality.
Once that time has elapsed the display returns to the indication of the temperature in
the cell.
During the flashing mode on the display use the
decrease the humidity setpoint desired.
Push the on/sby/enter button to confirm the new setpoint: the acquisition of the new
value is signalled by an acoustic emission of 3 short consecutive beeps.
After 2 seconds the display returns to the indication of the temperature in the cell.
DEFROST ICON
Led on: defrost in progress
Led blinking: defrost activation delay or dripping in progress
Led blinking at high frequency: alarm memorized
FAN ICON
Led on: room fans activated
Flashing LED: ventilator activation delay
COMPRESSOR ICON
Led on: compressor activated
Led blinking: compressor activation delay
TEMPERATURE SETPOINT SETTING/VARIATION
SMART FUNCTIONS – Quick-access functions
13
buttons to increase or