Sagi KP8G Manuel D'utilisation Et D'installation page 108

ALARM FOR END OF DEFROSTING ENDING DUE TO TIMEOUT (only on -25°C / -15°C and -22°C /+
5°C units)
In the event that the evaporator probe has not reached the pre-set value at the end of defrosting, the label
[tOd] alternating with the cell temperature will be shown on the display.
The buzzer can be turned off by pressing the key
Defrost may be either manual type or automatic type.
Manual defrost
Models +2°C / +10°C, -22°C / +5°C, +14°C / +16°C
The defrosting process can be stopped manually by pressing the "up" key again for 4 seconds. When the
process is stopped, a signal blinks on the label display [ndF].
Models -25°C / -15°C
In the -25°C / -15°C models, the defrost function must be activated by the user whenever a thick layer of
frost accumulates upon the shelves. In order to defrost the unit, turn it off by setting the panel to stand-by
mode, then open the door and remove the products. Remove the cap on the bottom and wait for all the frost
to melt. Use a sponge to direct all the water on the bottom into the drain hole. Clean the unit's interior
surfaces with a dry cloth and replace the cap on the bottom.ù
Automatic defrost
Automatic defrost is started during the conservation phase and is regulated by the card set-up.
The defrost operation can be manually interrupted by pressing the up button for 4 seconds: the deactivation
of the function will be indicated by the [ndF] label flashing on the display.
On the +14 °C / +16 °C and -25°C / -15°C units there is no automatic defrost".
. Pressing the next key
DEFROSTING
Push the button up for 4 sec seconds to immediately activate the defrost
cycle.
Just before the defrosting process begins, the temperature of the blocked cell
is displayed.
19
resets the alarm.