Control Pannels; Electronic Control Board - Sagi KP8G Manuel D'utilisation Et D'installation

The devices have one of the following commands:

Electronic control board

1

CONTROL PANNELS

ELECTRONIC CONTROL BOARD
5 6 7
2 3 4
ON/SBY/ENTER key
Press and release this key to check/change the appliance temperature setpoint.
Press this key for 3 seconds and release it as the display shows the [Sby] to set
the appliance to the stand-by mode.
When holding device in stand-by pressed [the display shows Sby], the controller
turns on.
UP and DOWN keys
These keys allow to increase or decrease the value of the parameter to be
changed.
Press these keys to display the min and max temperature recorded (if available)
and any alarm activated.
Pushed simultaneously these disable the keyboard blocking function.
The UP button, held down for a period exceeding 3 seconds,
activates/deactivates the manual defrost function.
The DOWN button, held down for a period exceeding 3 seconds, allows the
modification of the chamber humidity settings.
LIGHT key
Pushed and released allows the activation or the deactivation of the unit's interior
illumination.
UNITS +14 °C / +16 °C
Pushed and held down for over 3 seconds allows the temporary visualisation of
the humidity sensor reading, for 5 seconds, in a fixed display mode.
Electronic control board "touch"
12
POS DESCRIZIONE
1 Tasto ON/SBY/ENTER
2 Tasto DOWN
3 Tasto UP
4 Tasto LUCE
5 Icona SBRINAMENTO
6 Icona VENTOLA
7 Icona COMPRESSORE