Sagi KP8G Manuel D'utilisation Et D'installation page 111

more than 3 seconds: in confirmation of the operation on the display the message [UnL]
appears, flashing, accompanied by 3 short beeps of the buzzer.
Immediately afterwards, the display returns to the indication of the temperature in the cell.
With the keyboard locked, pressing any button, the instrument emits a long beep
indicating the [Loc] message on the display.
PROBE READING MANUAL PRINTING: Coupled with the TSP print terminal
Push the up and down buttons simultaneously and hold down for more than 3
seconds.
The label [Loc] is visualised.
Use the up and down buttons to visualise the [Prt] function.
Push the enter to confirm the choice and activate the function.
After 30 seconds, if not confirmed, the program exits the function.
PARAMETER CONFIGUTATION
Push the up and down buttons simultaneously and hold down for more than 3
seconds.
The label [Loc] is visualised.
Use the up and down keys to display the function [PAr].
Press the enter key to enter the parameter configuration mode.
After 30 seconds if not confirmed the program exits the function.
Enter the password to gain access.
The display shows the password setting mode [00]
Use the up and down keys to select the password "65"
Press the enter key to confirm your selection.
If the password is correct, the display shows the first parameter in the configuration
list.
Use the up and down keys to scroll the controller parameters
Press the enter key to confirm your selection.
The current value of the parameter selected in flashing mode is visualised.
Use the keys up and down to select the new value
Press the enter key to confirm your selection.
22