Parameter Configutation - Sagi KP8G Manuel D'utilisation Et D'installation

BLOCKIEREN DER TASTATUR
Push the up and down buttons simultaneously and hold down for more than 3
seconds.
The label [Loc] is visualised.
Push the on/sby/enter to confirm the choice and activate the function.
After 30 seconds if not confirmed the program exits the function.
To unblock the keyboard push the buttons simultaneously and hold down for
more than 5 seconds: to confirm this operation the [UnL] will flash on the display.
When the keyboard is blocked the label [Loc] will appear on the display when any
key is pressed.
PROBE READING MANUAL PRINTING: Coupled with the TSP print terminal
( only on -25° C / -15° C and -22° C / + 5° C units)
Push the up and down buttons simultaneously and hold down for more than 3
seconds.
The label [Loc] is visualised.
Utilise the up button to visualise the [Prt] function.
Push the on/sby/enter to confirm the choice and activate the function.
After 30 seconds, if not confirmed, the program exits the function.

PARAMETER CONFIGUTATION

Push the up and down buttons simultaneously and hold down for more than 3
seconds.
The label [Loc] is visualised.
Use the up and down keys to display the function [PAr].
Press the on/sby/enter key to enter the parameter configuration mode.
After 30 seconds if not confirmed the program exits the function.
Enter the password to gain access.
The display shows the password setting mode [00]
Use the up and down keys to select the password "65"
Press the on/sby/enter key to confirm your selection.
If the password is correct, the display shows the first parameter in the configuration
list.
Use the up and down keys to scroll the controller parameters
14