Parameter Configutation - Sagi KP8V Manuel D'utilisation Et Instructions Originales

PARAMETER CONFIGUTATION

Information accessible to qualified staff only.
Push the up and down buttons simultaneously and hold down for more
than 3 seconds.
The label [Loc] is visualised.
Use the up and down keys to display the function [PAr].
Press the enter key to enter the parameter configuration mode.
After 30 seconds if not confirmed the program exits the function.
Enter the password to gain access.
The display shows the password setting mode [00]
Use the up and down keys to select the password "-17"
Press the enter key to confirm your selection.
If the password is correct, the display shows the first parameter in the
configuration list.
Use the up and down keys to scroll the controller parameters
Press the enter key to confirm your selection.
The current value of the parameter selected in flashing mode is
visualised.
Use the keys up and down to select the new value
Press the enter key to confirm your selection.
USER PARAMETER CONFIGURATION - PROBE READING
Push the up and down buttons simultaneously and hold down for more
than 3 seconds.
The label [Loc] is visualised.
Utilise the up and down buttons to scroll the sensor probe readings and
the user parameters.
Press the enter key to confirm your selection and enter the mode for
reading probes or changing parameters.
The current value blinks on the display.
20