Managing Lighting - Sagi KP8V Manuel D'utilisation Et Instructions Originales

Vitrine verticale réfrigérée
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 33
Press the enter button again to confirm the new set point: the
acquisition of the new value is signalled by an acoustic emission of 3
short consecutive beeps
Push the up and down buttons simultaneously and hold down for more
than 3 seconds.
The label [Loc] is visualised.
Push the enter to confirm the choice and activate the function.
After 30 seconds if not confirmed the program exits the function.
To unlock the keyboard it is necessary to press the
simultaneously for more than 3 seconds: in confirmation of the operation
on the display the message [UnL] appears, flashing, accompanied by 3
short beeps of the buzzer.
Immediately afterwards, the display returns to the indication of the
temperature in the cell.
With the keyboard locked, pressing any button, the instrument emits a
long beep indicating the [Loc] message on the display.
Press and release the light button to switch the internal lighting of the
unit on or off. This operation can also be performed in Stand-by mode.
When the lights are on, press and hold the key to change the lighting
shade.
It is possible to choose between 4 different shades in sequence:
- cold light (6000 K)
- intermediate light 1 (5000 K)
- intermediate light 2 (4000 K)
- warm light (3000 K)
The selection made stays in the memory, even after switching the unit
off and on again.
The lighting intensity of the internal compartment is automatically controlled by the
electronic card according to the signal coming from the PIR proximity sensor. The
luminous flux is more intense when the sensor detects people near the unit.
The lighting intensity is automatically reduced after some time has elapsed without the
sensor detecting movement in the vicinity of the unit.
Disable the PIR sensor or change the stay time at the maximum light intensity after its
activation by going into change parameters configuration. When the PIR sensor is
disabled, lighting is always set to maximum intensity.
BLOCKIEREN DER TASTATUR

MANAGING LIGHTING

19
buttons

Publicité

Table des Matières
loading

Table des Matières