Defrosting; Stopping - Sagi KP8V Manuel D'utilisation Et Instructions Originales

If during the maximum time assigned to the defrost the value is not reached, the display
displays the label [tOd] alternating with the cell temperature. A buzzer is also activated.
The buzzer can be turned off by pressing the key
Pressing the next key
Defrost may be either manual type or automatic type.
Manual defrost
Models +2°C / +10°C, -22°C / +5°C, +14°C / +16°C
Push the button defrost for 4 sec seconds to immediately activate the
defrost cycle.
Just before the defrosting process begins, the temperature of the
blocked cell is displayed.
The defrosting process can be stopped manually by pressing the
seconds. When the process is stopped, a signal blinks on the label display [ndF]
Models -25°C / -15°C
In the -25°C / -15°C models, the defrost function must be activated by the user whenever a
thick layer of frost accumulates upon the shelves. In order to defrost the unit, turn it off by
setting the panel to stand-by mode, then open the door and remove the products. Remove
the cap on the bottom and wait for all the frost to melt. Use a sponge to direct all the water
on the bottom into the drain hole. Clean the unit's interior surfaces with a dry cloth and
replace the cap on the bottom.
Automatic defrost
Automatic defrost is started during the conservation phase and is regulated by the card
set-up.
The defrost operation can be manually interrupted by pressing the up button for 4
seconds: the deactivation of the function will be indicated by the [ndF] label flashing on the
display.
On the +14 °C / +16 °C and -25°C / -15°C units there is no automatic defrost".
Press this key for 3 seconds and release it as the display shows the [Sby] to set the
appliance to the stand-by mode.
WARNING: the main switch
current.
resets the alarm; the display returns to the current view.

DEFROSTING

STOPPING

DOES NOT insulate the machine from the electric
27
.
: key again for 4