Sagi KP8V Manuel D'utilisation Et Instructions Originales page 108

TEMPERATURE SETPOINT SETTING/VARIATION
Press and release the key enter: the current setpoint blinks on the
display for 5 seconds.
After 5 seconds, the displays shows the room temperature again
While the display is blinking, use the up and down keys to increase or
decrease the temperature setpoint
Press the enter button again to confirm the new set point: the
acquisition of the new value is signalled by an acoustic emission of 3
short consecutive beeps.
The display returns to the indication of the temperature in the cell.
SMART FUNCTIONS – Quick-access functions
Forced manual defrost
Push the defrost button for more than 3 seconds to access the manual
defrost functions.
With the defrost in progress press the button again for a period greater
than 3 seconds to end the defrost phase.
Change in relative humidity +2°C/+10°C and -22°C/+5°C
Push the down button, hold down for more than 3 seconds to modify the
percentage of relative humidity in the chamber.
The temporary flashing confirmation label [F_C] corresponds to a too
low relative humidity (fans in parallel with the compressor).
The flashing temporary confirmation label [F_ _] corresponds to a too
high relative humidity (fans independent).
The relative humidity that blinks on the temporary label [FtE] is
programmed by the manufacturer.
Change in relative humidity +14°C/+16°C
Press and release the key enter: the current setpoint blinks on the
display for 5 seconds.
After 5 seconds, the displays shows the room temperature again
Press the enter button again: humidity setpoint blinks on the display for
5 seconds.
After 5 seconds, the displays shows the room temperature again.
During the setting of the humidity setpoint, the °C or °F icons of the
display is off.
While the display is blinking, use the up and down keys to increase or
decrease the humidity setpoint
18