General Cleaning And Maintenance - Sagi KP8V Manuel D'utilisation Et Instructions Originales

• To unhook the shelf follow the previous directions in reverse order.
Check and verify that the line voltage corresponds to that found on the
technical specifications plaque on the unit. The manufacturer recommends
that a sole use circuit be dedicated for the unit.
WARNING: An omnipolar switch is to be installed before the appliance, in
compliance with the current regulations applied in the country where the
appliance is installed.
Also recommended to install a differential switch.
Then insert the plug into the current tap.
Now the installation has come to end.

GENERAL CLEANING AND MAINTENANCE

For regular and constant service of the unit it would be well to regularly carry out general
cleaning and maintenance operations.
WARNING: The cleaning and maintenance of the refrigerating engine and the compressor
area needs the intervention of a skilled technician, therefore it cannot be done by other
persons.
The air condenser should be kept clean to ensure the device performance and efficiency,
as air should circulate inside the device without barrier.
WARNING: The condenser should therefore be cleaned every 30 days or as needed
A dirty Condenser can result in NON-WARRANTEED part & Compressor Failures, Product
Loss.
Before to begin with the operations proceed as following:
- set the general cut-out in OFF position;
- remove the plug from the socket and wait till the complete entfrosting of the unit.
To access the condenser it is necessary to remove the front dashboard:
1. Remove the lower instrument panel, grasping it on the side, freeing it from the four
retaining bolts.
2. remove the filter placed on the condenser
3. thoroughly clean the filter with a vacuum cleaner
4. use a vacuum cleaner, brush or non-metallic brush to carefully clean the condenser
13