Control Pannels - Sagi KP8V Manuel D'utilisation Et Instructions Originales

The unit is equipped with a DISPLAY (A) located at the bottom front and a CONTROL
KEYBOARD (B) located below it. Open the door on the instrument panel to access the
keyboard.
The unit is also equipped with a PIR SENSOR (C) able to detect the presence of people
near the unit itself and to automatically change the internal lighting level.
A
C
DISPLAY
1
2
3
4
CONTROL KEYBOARD
9
10

CONTROL PANNELS

11 12 13
ON/STAND-BY key
Con strumento in stand by [a display compare Sby], premuto, il
controllore si accende.
Premuto per 3 secondi, rilasciato alla comparsa sul display della
label [Sby], porta l'apparecchio in stand–by.
ENTER key
Press and release this key to check/change the appliance
temperature setpoint; during operations the above mentioned
backlighting is flashing.
Confirms the numerical value set in parameters configuration.
Confirms the selection of a parameter or function.
With the card in stand-by mode, pressed continuously for 10
seconds, it lets you select the password-protected parameter map.
B
POS
5
6
7
8
14
16
DESCRIPTION
1 COMPRESSOR ICON
2 DEFROST ICON
3 FAN ICON
4 HACCP ICON
5 °C ICON
6 °F ICON
7 LIGHT ICON
8 ON / OFF ICON
9 ON/STAND-BY KEY
10 ENTER KEY
11 DOWN KEY
12 UP KEY
13 DEFROST KEY
14 LIGHT KEY