Installation - Sagi KP8V Manuel D'utilisation Et Instructions Originales

INSTALLATION

The units are always shipped on pallets and protected by cardboard boxes.
On receiving and after having unpacked in case of dammages or missing pieces act as
described in the chapter "GENERAL NOTES BY THE DELIVERY".
All setting up and starting operations are to be carried out by skilled staff.
WARNING: package parts (plastic bags, polystyrene foam, nails and the like) are
dangerous for children and must not be left within their reach.
Lift the unit with a forklift and move it to its
place of installation paying close attention that
the load is well balanced.
WARNING: overturning hazard: Never tilt the unit. During handling
make sure that it is stabilised by qualified personnel.
WARNING: never transport the unit in a horizontal position; such an
operation could cause damage to the structure and or to the operational
plant.
WARNING: this appliance must not be installed in rooms with a volume
lower than 30 m³.
Once on the installation site, proceed as
follows.
Remove the packing box, adhesive
tape and any styrofoam pieces.
Remove the plate behind the
appliance.
C
Pull out strips A, B and C located at the base
of the package, removing the fixing screws
first.
A
B
Insert the A strips under the wheels of the appliance.
A
A
10