Sagi KP8G Manuel D'utilisation Et D'installation page 110

Press and release the key enter: the current setpoint blinks on the display for 5
seconds.
After 5 seconds, the displays shows the room temperature again
While the display is blinking, use the up and down keys to increase or decrease the
temperature setpoint
Press the enter button again to confirm the new set point: the acquisition of the new
value is signalled by an acoustic emission of 3 short consecutive beeps.
The display returns to the indication of the temperature in the cell.
Forced manual defrost
Push the defrost button for more than 3 seconds to access the manual defrost
functions.
With the defrost in progress press the button again for a period greater than 3
seconds to end the defrost phase.
Change in relative humidity +2°C/+10°C and -22°C/+5°C
Push the down button, hold down for more than 3 seconds to modify the percentage
of relative humidity in the chamber.
The temporary flashing confirmation label [F_C] corresponds to a too low relative
humidity (fans in parallel with the compressor).
The flashing temporary confirmation label [F_ _] corresponds to a too high relative
humidity (fans independent).
The relative humidity that blinks on the temporary label [FtE] is programmed by the
manufacturer.
Change in relative humidity +14°C/+16°C
Push the down button and hold down for more than 3 seconds: the display visualises
the current humidity setpoint for 5 seconds in a flashing modality.
Once that time has elapsed the display returns to the indication of the temperature in
the cell.
During the flashing mode on the display use the
decrease the humidity setpoint desired.
Push the enter button to confirm the new setpoint: the acquisition of the new value is
signalled by an acoustic emission of 3 short consecutive beeps.
After 2 seconds the display returns to the indication of the temperature in the cell.
Push the up and down buttons simultaneously and hold down for more than 3
seconds.
The label [Loc] is visualised.
Push the enter to confirm the choice and activate the function.
After 30 seconds if not confirmed the program exits the function.
To unlock the keyboard it is necessary to press the
TEMPERATURE SETPOINT SETTING/VARIATION
SMART FUNCTIONS – Quick-access functions
BLOCKIEREN DER TASTATUR
21
buttons to increase or
buttons simultaneously for