Implementation And Installation - Sagi KP8G Manuel D'utilisation Et D'installation

IMPLEMENTATION AND INSTALLATION

The units are always shipped on pallets and protected by cardboard boxes.
On receiving and after having unpacked in case of dammages or missing pieces act as described in the
chapter "GENERAL NOTES BY THE DELIVERY".
All setting up and starting operations are to be carried out by skilled staff.
WARNING: package parts (plastic bags, polystyrene foam, nails and the like) are dangerous for children and
must not be left within their reach.
Lift the unit with a forklift and move it to its place of installation paying close attention that the load is well
balanced.
WARNING: overturning hazard: Never tilt the unit. During handling make sure that it is stabilised by qualified
personnel.
WARNING: never transport the unit in a horizontal position; such an operation could cause damage to the
structure and or to the operational plant.
WARNING: this appliance must not be installed in rooms with a volume lower than 30 m³.
Once on the installation site, proceed as follows.
Remove the packing box, adhesive tape and any styrofoam pieces.
Remove the plate behind the appliance.
Pull out strips A, B and C located at the base of the package, removing the fixing screws first.
C
A
B
6